Split ATEX cable entry frame, NEMA 4X / IP65
Split cable entry frame with ATEX certification for pre-terminated cables with protection up to NEMA type 4X / IP65.
For use in potentially explosive atmospheres and hazardous areas, icotek offers a wide range of cable entry components certified to the ATEX directive.
ATEX stands for “ATmosphères EXplosives“ and is the short name for the European Directive 2014/34/EU, regulating the market launch of explosion protected electrical and non-electrical devices, components and protection systems used in hazardous areas. This has been in place since July 1, 2003, it applies to all new equipment and protective devices in potentially hazardous environments.
icotek ATEX products are suitable for for zones G (gas) and D (dust) in equipment group II, category 2+3. The icotek cable entry components comply with the EU Directive 2014/34/EU for equipment and protective systems intended for use in potentially explosive atmospheres of zones 1, 2, 21 and 22.
icotek ATEX cable entry devices for hazardous areas are only suitable for fixed installation of cables where strain and torsional loading on the cable is not possible.
Other product categories:
Cable entry systems & cable glands for cables with connectors | Cable entry plates, membrane based for cables without connectors | Cable pass-through with brush seal | Strain relief & cable management | EMC cable clamps | CONFiX cable conduit system | Control panel accessories | Hand hydraulic punch drivers & knockout punches
ATEX certified cable entry plates for standard cables. High cable density, sealing rates up to NEMA type 12 / IP66.